Amatucci Roofing fits gutter guards on Shillington roofs from a Wernersville shop 7.8 miles out, with the phone answered around the clock.
Amatucci Roofing works out of Wernersville, 7.8 miles from Shillington, and fits gutter guards on Berks County roofs. The crew clears the gutter first, then sets the guard over a run that drains.
A guard keeps leaves off the gutter, and the water that once spilled over the lip stays inside the run. The crew water-tests every Shillington job before the ladders come down.
A Shillington gutter guard job covers four pieces of work: a gutter clean-out, a fit check, the guard run, and a water test.
Leaves, shingle grit and roof dirt leave the gutter before a guard goes on, because a guard set over packed debris seals the blockage in. The crew flushes the run and checks the fall toward each downspout.
Gutter on a Shillington home runs 5 inches or 6 inches wide, and the hanger spacing varies with the age of the fascia board. The crew measures the lip, the hanger spacing and the roof pitch before a guard type is picked.
Perforated aluminum and micro-mesh guards clip or screw to the gutter lip. The guard never slides under the first shingle course, so the roof edge stays as built. The crew runs guard along the full length of the Shillington gutter.
A hose test at the end proves the water runs from the roof edge to the downspout with the guard on. Amatucci Roofing answers the phone around the clock, so a Shillington gutter pulling loose in a storm reaches a roofer the same night.
Learn more about our Gutter Guard Installation Services.
The crew fits gutter guards on a Shillington home in four steps, from the ladder set to the last water test.
The visit starts at the gutter line, with the ladder on solid ground and standoffs off the run. The crew walks the full gutter, notes loose hangers, rotted fascia board and low spots, and measures the Shillington run end to end.
Every foot of gutter is cleared by hand, then flushed with a hose from the high end. Hangers that have dropped are reset, so the gutter falls toward the downspout at the rate the roof edge needs.
Guard stock is cut to the length of each gutter section, including the corners and the outlet drops. The crew fastens the guard to the lip or the hanger, keeps the shingle course untouched, and seals the joints where two lengths meet.
A hose runs on the roof for the final check, and the crew watches every Shillington downspout for flow. Debris from the clean-out leaves with the crew, the ground under the gutter line is raked, and photos of the run go to the homeowner.
The crew hangs guards on Shillington borough roofs and on the blocks outside the borough line:
Shillington homeowners ask about price, permits, ice dams and the older gutter runs on the borough streets.
Areas We Serve in Shillington
